For example, there’s no voltage display after connecting the lamphead to the battery The LED indications will be reduced to a minimum. Example: When it‘s deactivated the default light setting would only light with 20W and 6W. The diffuse light level can be activated or deactivated in the respective light program. You choose and setup the diffuse light or SOS further down in the programming To activate diffuse light or SOS (depending on the programming), keep the button of the lamphead pressed until it lights up red once, let go immediately. Runtime varies according to battery age, and condition, as well as ambient temperature. When taking your finger off the button accordingly, the setting will be saved.

They are very easy to select by simply keeping the button pressed until the button’s red or blue LED flashes once, twice, etc. So slow down! Note: The burn time remaining after the red LED is illuminated depends on the total battery capacity, the ambient temperature and the age of the battery Programmingīy default, the Piko R operates in the 3-step mode, several other light programs are available. When reserve power is completely discharged, the light will be switched off automatically. blue + red LED flashing in turn: After switching the light on again, reserve power at a low beam is available.

Stop immediately! The light will be switched off. blue + red LED flashing in turn + light flashing 5 times: Warning! The red and blue LED flashing in turn, the lamp flashes 30 times. The red LED is flashing and Piko R flashing ones, too.

Battery Warning, very low capacity remaining. red LED flashing + light flashing once: 2. You can adjust the timing of the battery warning, see progamming on next page. The switch on the lamphead as well as the Bluetooth remote are equipped with a RGB-LED to show information about the dim level and the remaining battery capacity. If the light is not cooled by airflow, its power is reduced incrementally to prevent the LEDs and electronic elements from overheating. Note: The light outputs the maximum amount of light only if airflow lowers the temperature of the light sufficiently. To turn off the lamp, keep the button pressed. The blue LED is illuminated.Įach quick push of the button switches through the dim levels. The first press of the button switches on the light with maximum power. 6.5 to 7 V : battery is not ready for use.more than 8.0 V: battery is fully charged:.the red LED flashes once for each 1/10 of a volt.Įxample: The LED flashes seven times blue and five times red = battery voltage is 7.5 V.The blue LED flashes once for each volt and then.The battery voltage is indicated by the blue and red LEDs, as follows: The lamp itself as well as the red and blue LEDs in the switch light up once. After connecting the lamp to the battery, the software runs a selftest.

Solar 670 fleet battery charger manual